suhoogl.blogg.se - Smartscope labnation wiki

#Smartscope labnation wiki install#
#Smartscope labnation wiki serial#
#Smartscope labnation wiki download#

You'll see a toast that a SmartScope has been found on the same network, after which you can control the SmartScope as if it were connected locally! Next, simply start the SmartScope app on your device. In case the bridge is connected to an existing AP, make sure your device is also connected to that same AP.In case of the bridge's AP, make sure your device is connected to the SmartScope XXXX AP.Just make sure that both the Wifi bridge and your device are connected to the same network: Whenever it is not possible to connect to an existing Access Point, or when the connection to an existing Access Point is lost for 15 seconds, the Wifi bridge resets and sets up its own Access PointĬonnecting your device/pc/tablet/phone to the SmartScope on the Wifi bridge

#Smartscope labnation wiki serial#

Otherwise, the Wifi bridge will set up its own Access Point named SmartScope XXXX (where XXXX is the bridge serial number).

In case the Wifi bridge was connected to an existing Access Point, the wifi bridge will try to reconnect using the same credentials as last time.

As soon as a SmartScope has been detected, the bridge will load the last configuration.

After booting, the wifi bridge will wait for a SmartScope to be connected to its USB port.

When the Wifi bridge is set to Active mode by switching the Main switch to its rightmost position, the Wifi bridge will cycle through the following states:

#Smartscope labnation wiki install#

Linux: pre-installed on most distributions, otherwise you need to install the avahi-deamon package.

#Smartscope labnation wiki download#

Windows: download and install Apple's Bonjour service from.

it probably means there is no ZeroConf service installed on the client machine, which is required to auto-detect the scope on the network.

Start the SmartScope app on that device!.

Connect any device to the SmartScope WiFi.

Hook up a SmartScope to the USB port of the WiFi Bridge.Switch the WifiBridge to Active mode by moving the main switch to the outer right position.2.4 Switching from an exsiting AccessPoint back to the bridge's own AccessPoint.2.3 Switching from own AccessPoint to an existing AccessPoint.2.2 Connecting your device/pc/tablet/phone to the SmartScope on the Wifi bridge.Leave your SmartScope at a test setup, and you can visualize the result from your chair.Cases where a wired connection is just not that practical.Last but not least, you can use the SmartScope WiFi Brige as a standard 4400mAh USB battery pack to charge any USB device :).In case this would not be enough, you can charge the WiFi Bridge while it is operating.Internal 4400mAh battery allows 9h+ of wireless connectivity to the SmartScope (full performance over WiFi).Simply download the SmartScope app from the regular AppStore, and it will connect to a SmartScopeServer running in the network! Allows to control a SmartScope from a (non-jailbroken) iPhone/iPad.The WiFi Bridge and client GUI both implement ZeroConf, which means that you don't need to input any IP address - they will find each other automatically. The battery-operated SmartScope WiFi Bridge allows you to power and use your SmartScope over a wireless or wired network connection.īecause the SmartScope WiFi Bridge includes a battery, all you need to do is connect your SmartScope to the WiFi bridge and you can use any tablet/phone/PC on the network to run the GUI!